Bluetooth Caliper adalah alat yang dapat dengan cepat mengukur jarak dalam milimeter antara dua titik dan mentransfer nilai ke PC melalui Bluetooth. Ini mempercepat mendaftarkan bentuk pohon yang tidak beraturan dan posisi sensor atau elektroda untuk ArborSonic 3D dan untuk ArborElectro
usage instruction
- Insert the two arms of the caliper into the slots on the main part.
- Calibrate the caliper
- Start the ArborSonic 3D software or application and go to the Geometry page or start the ArborElectro software and go to Sensor Layout tab. To use the caliper, select Irregular shape.
- Turn on the caliper and click the Start Bt Caliper or Start button.
- Measure the distances between the sensor pairs by following the instructions played through the speakers of the PC. Once all the points are registered, the shape of the trunk is shown on the screen
- The caliper turns off automatically after 60 seconds of the last data transmission
package content
- Display unit with screen, battery and electronics
- Measuring arms ending in pins
- Extension arms (optional)
- Textile case
- Charging cable (USB)
- Manual
- Wrench 28
technical specification
Range 1100 mm or 1999 mm
Resolution 1 mm
Accuracy 2 mm
Weight 2.3 kg
Material Carbon fiber reinforced plastic, aluminium
Dimensions (packed) 77 cm x 18 cm x 11 cm
Dimensions (unpacked) 155 cm x 95 cm x 6 cm
Connection to PC Bluetooth